Passat Wagon V6-2792cc 2.8L DOHC (1994)
Crankshaft: Service and Repair
Drive Plate, Removing and Installing
Drive Plate, Removing And Installing
Special Tools Needed:
-
Counter-hold tool VW 558
-
Depth gage
-
Torque wrench 40 - 200 Nm (30 - 150 ft lb)
Removing
-
Install counter-hold tool VW 558 with bolt M8X45 in drive plate. Place two nuts between counter-hold tool and drive plate.
Installing
-
Install drive plate to crankshaft.
-
Insert at least three old bolts and tighten to 30 Nm (22 ft lb).
-
Using straight edge (left arrow) and depth gauge, measure dimension -a- through three bolt holes (right arrows) and calculate average
measurement.
-
Compare average measurement with specifications (measured distance plus thickness of straight edge).
Specification: 15.7 to 16.5 mm
-
If what you measured is less:
