Passat Wagon V6-2792cc 2.8L DOHC (1994)
-
Press in oil seal up to stop with sleeve of 3266. Use old vibration damper bolt.
-
Install vibration damper and lock, using counter-hold tool 3273.
-
Tighten new bolt to 100 Nm (74 ft lb) and turn 1/4 turn (90°) further.
NOTE: Replace bolt for vibration damper. When tightening bolt be sure that crankshaft does not turn.
-
Ribbed belt, installing refer to "Ribbed Belt, Removing and Installing". See: Drive Belts, Mounts, Brackets and Accessories/Ribbed
Belt/Service and Repair