Passat Wagon V6-2792cc 2.8L DOHC (1994)
INSTALLATION
1. Insert axle shaft into hub, then install wheel bearing housing onto strut bracket. Install cam bolts, if installed, and through bolts. Align reference
marks on cam bolt and tighten through bolt to specifications.
2. Install ball to control arm, then tighten bolts to specifications.
3. Connect tie rod to wheel bearing housing and tighten retaining nut to specifications. Install new cotter pin.
4. Install brake rotor and caliper.
5. Install wheel and axle shaft to hub retaining nut, then lower vehicle and tighten to specifications.
