Passat Wagon V6-2792cc 2.8L DOHC (1994)
10 - Piston
- Sealing lips ore vulcanized to piston
- Moisten with ATF before in stalling
- Turn piston slightly while installing
11 - Clutch housing with pump shaft
- Height varies according to number of inner and outer plates
12 - Piston ring
- Replace only faulty piston rings
- Piston ring is destroyed when removed
- Check that ring is correctly located - Fig. 2
- Installing - Fig. 3
13 - Piston ring
- Replace only faulty piston rings
- Unhook ends to remove
- Check that ring is correctly located - Fig. 2
- Installing - Fig. 3
Fig. 1
Fig. 1 Removing and installing circlip (arrow)
- Press down carefully on piston Lap until the circlip can be installed.
Fig. 2
Fig. 2 Checking that piston rings are correctly located
There is a piston ring installed on the turbine shaft inside the clutch housing (-arrow-).
- Make sure that ends of piston rings are hooked together