Volkswagen Workshop Service and Repair Manuals

• ‒ Remove window lifter .
• ‒ → Remove Qty. 3 cross-head screws -1- from the window lifter/lifter motor joint.
• ‒ Remove spacer sleeves -2-.

• ‒ → Turn window lifter around and remove cross-head screws -1- (Qty. 5).
• ‒ Open hinge -3- and take connector -2- out of mounting.
• ‒ Pull the cable drum -4-, by hand, off the gear housing by tilting slightly in alternate directions.

• ‒ → Pull drive gear -1- off gear shaft in direction of arrow. Pay attention to spacer washer -2-.

Note:

The damper element -3- must fit exactly in the cable drum recesses.

• ‒ → Insert drive gear -2- into cable drum, fit spacer washer -1- onto drive gear.
• ‒ Pull fitting cover off new motor.

Note:

Surfaces/parts coated with grease must not come into contact with dust or dirt. Regreasing only with original grease G 000 450 02.

• ‒ → Check that the cable is correctly positioned on the cable drum.
• ‒ Join cable drum and electric motor together.

• ‒ If it is not possible to join together the gear housing and the cable drum as far as the stop, alter the position/attitude of the drive gear by moving the motor slightly so that the drive gear engages.
• ‒ → Screw in securing screws and tighten in the specified order (3 Nm).

• ‒ → Press connector -2- into housing and close hinge -3-.

Note:

Perform functional check before installing.

Replacement of the mechanical part (linkage/cable) is performed in the same manner.