Polo Mk3
Installing and adjusting heating and air conditioning cables |
Note
t | The cable sheaths are colour coded. |
t | Check cables before installing; replace stiff or damaged cables. |
t | First connect cables to removed controls, then adjust cables at air conditioner levers and secure them. |
t | When control knobs are turned, all flaps must audibly contact stop. |
1 - | Central flap cable |
q | From air distribution rotary control to central flap. |
q | Identification of cable sleeve: left-hand drive: yellow; right-hand drive: grey. |
q | Adjusting cable at central flap → Chapter. |
2 - | Footwell/defroster flap cable |
q | From air distribution rotary knob to footwell/defroster flap. |
q | Identification of cable sleeve: left-hand drive: green; right-hand drive: black. |
Renewing: |
– | Remove heating and air conditioning controls → Chapter. |
– | Remove driver side footwell cover → Rep. Gr.68. |
– | Unclip cable on heater and air conditioner unit. |
– | Adjust cable at footwell/defroster flap → Chapter. |
3 - | Heating and air conditioning controls |
q | Removing → Chapter. |
4 - | Temperature flap cable |
q | From temperature rotary knob to temperature flap. |
q | Identification of cable sleeve: left-hand drive: beige; right-hand drive: white. |
q | Adjusting cable at temperature flap → Chapter. |