volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Removing and installing fresh air blower series resistor with overheating fuse N24 > < Passenger compartment heating
Before beginning repair work, perform the following steps:
Before beginning repair work, perform the following steps:
–  Switch off all electrical consumers.
–  Switch off ignition.
–  Pull out ignition key.
   
1 - Left plenum chamber cover
2 - Right plenum chamber cover
q   Removing and installing → Chapter.
3 - Dust and pollen filter
q   Removing → Chapter.
4 - Dash panel
q   Removing and installing → Rep. Gr.70.
5 - Right vent
q   Removing → Chapter.
q   Do not dismantle further (vent and adjustable louver are one spare part).
6 - Air distribution duct, upper part
q   Renewing: remove centre vent → Item and remove air distribution duct → Item.
7 - Right air duct
q   Removing and installing: first remove glove box or front passenger side airbag unit → Rep. Gr.69.
8 - Hexagon nut M6
q   5 Nm.
9 - Heater unit
q   Removing and installing → Chapter.
10 - Fresh air blower -V2-
q   Removing → Chapter.
11 - Fresh air blower series resistor with overheating fuse -N24-
q   Removing and installing → Chapter.
12 - Trim panel for controls
q   Carefully unclip using screwdriver.
13 - Central flap lever
q   Removing and installing: first remove footwell vents → Item and → Item.
14 - Temperature flap lever
q   Removing and installing: first remove footwell vents → Item and → Item.
15 - Controls for fresh and heated air
q   Removing and installing → Chapter.
q   Dismantling and assembling → Chapter.
q   Installing and adjusting cables → Chapter.
16 - Rear duct
q   Renewing: first remove centre console, footwell vents → Item and → Item, seats and carpet.
17 - Seal for rear duct
q   Renewing: first remove footwell vent → Item.
18 - Footwell vent, lower part
q   Removing and installing → Chapter.
19 - Air duct grille
20 - Footwell vent, lower part
q   Removing and installing → Chapter.
21 - Cables
q   Renewing: first remove centre vent → Item, footwell vents → Item and front passenger side compartment
q   Installing and adjusting → Chapter.
22 - Air distribution duct, lower part
q   Renewing: remove centre vent → Item.
23 - Seal
q   Renew.
24 - Intermediate piece
q   With seal.
q   Renewing: first remove dash panel → Rep. Gr.70.
25 - Heat exchanger
q   Renewing: remove heater unit → Chapter.
q   Removing and installing: → Chapter.
q   After removal, completely renew coolant.
26 - Left air duct
q   Removing and installing: first remove left vent → Item and dash panel insert.
27 - Left vent
q   Removing → Chapter.
q   Do not dismantle further (vent and adjustable louver are one spare part).
28 - Central vents
q   Removing → Chapter.
29 - Adjustable louver
q   For centre vent.
–  Carefully pull out using long nose pliers.

   

Removing and installing fresh air blower series resistor with overheating fuse N24 > < Passenger compartment heating