Initiating basic setting
Initiating basic setting
The basic setting should be initiated after performing the following repairs:
-
◆ Exchanging engine
-
◆ Replacing or coding engine control unit
-
◆ Removing and installing gearbox
-
◆ Removing and installing "electronic accelerator"
-
◆ Replacing throttle valve potentiometer -G69-
-
◆ Altering throttle valve potentiometer -G69- setting e.g. when adjusting idling switch (engine)
-
◆ Removing and installing kick-down switch
-
◆ Replacing automatic gearbox control unit -J217-
=> "Special Information Bulletins" binder; Engine; No. 4
-
‒ Connect fault reader V.A.G 1551 and enter address word "02 Gearbox electronics" and advance until "Select function XX" appears in the display => from page 01-13
.
|