Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Installing >
< Renewing valve stem seals
Polo Mk3
Power unit
4-cylinder injection engine (2-valve), mechanics
Engine cylinder head, valve gear
Repairing valve gear / newing_valve_stem_seals/">Renewing valve stem seals
Removing
Removing
Removing
–
First remove toothed belt
→ Chapter
.
–
Then remove camshaft
→ Chapter
.
–
Remove bucket tappets and place them with the contact surface downwards. When doing this, ensure that tappets are not interchanged.
–
Remove spark plugs.
–
Set piston of respective cylinder to “bottom dead centre”.
–
Fit valve assembly tool -2036- and adjust mountings to height of studs.
–
Screw pressure hose -VW 653/3- into spark plug thread.
–
Connect pressure hose to air pressure source of at least 6 bar.
–
Remove valve springs using valve lever -VW 541/1 A- and thrust piece for VW 541 / 1 A and 2037 -VW 541/5-.
Note
Tight cotters can be loosened by tapping lightly on lever.
–
Pull off valve stem seals using puller -3047 A-.
Power unit
4-cylinder injection engine (2-valve), mechanics
Engine cylinder head, valve gear
Repairing valve gear / newing_valve_stem_seals/">Renewing valve stem seals
Removing
Installing >
< Renewing valve stem seals