Polo Mk3
Part II |
1 - | 5 Nm + 1/4 turn (90 °) further |
q | Renew |
2 - | Sealing washer |
q | Renew |
3 - | Cylinder head cover |
4 - | Sealing cover |
q | Renew seal if damaged |
5 - | Cylinder head cover gasket |
q | Renew if damaged |
q | Before fitting coat transition points between bearing cap and cylinder head with sealant -D 454 300 A2-. |
6 - | Cylinder head bolt |
q | Renew |
q | Note installation instructions and sequence when loosening and tightening → Chapter. |
7 - | Cylinder head |
q | Removing and installing → Chapter |
q | After renewing, renew entire coolant |
8 - | Cylinder head gasket |
q | Renew |
q | Engine codes: ADX, AEA, AEE, AER, AEX, AKV, ALL, ANX, APQ: metal gasket |
q | After renewing, renew entire coolant |