volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Dismantling and assembling fuel rail with injectors > < Removing and installing parts of the injection system
4CV fuel injection and ignition system
Servicing injection system
Dismantling and assembling intake manifold
 
N24-0815
  • Throttle valve control part (J338)*
    • ◆ Components of the throttle valve control part (J338):
      Throttle valve positioner (V60)*/**, throttle valve potentiometer (G88) *, throttle valve potentiometer (G69)* and idling switch (F60)*
    • ◆ Checking
    • ◆ If replaced match engine control unit => Page 24-112
    • ◆ If replaced adapt control unit for automatic gearbox:

=> Self-diagnosis for automatic gearbox 001; Repair group 01; Performing self-diagnosis; Introduce basic setting

 
N24-0815
  • 10 Nm
  • Gasket
    • ◆ Note installation position
    • ◆ Renew
  • Intake connecting flange
  • Seal
    • ◆ Renew if damaged
  • 20 Nm
  • Seal
    • ◆ Renew
  • Guide plate
    • ◆ Note installation position
    • ◆ Renew if damaged
  • O ring
    • ◆ Renew if damaged
  • 3 Nm
 
N24-0815
  • Intake manifold pressure sender (G71)* with intake air temperature sender (G42)*
    • ◆ Checking intake manifold pressure sender
    • ◆ Checking intake air temperature sender
    • ◆ Intake air temperature sender resistance values between contacts 1 and 2 , Fig. 2
  • Intake manifold
    • ◆ Removing and installing
      , removing and installing parts of the injection system
  • Vacuum hose
    • ◆ From fuel pressure regulator
      => Page 24-23 , item 12

Dismantling and assembling fuel rail with injectors > < Removing and installing parts of the injection system