-
‒ Press the ⇒key.
-
‒ Press keys 0 and 6 for the function "End output" and confirm entry with the Q key.
-
‒ Eliminate the printed out faults using the appropriate fault table.
=> Page 01-10
.
During test and assembly work faults can be recognised from other control units like e.g. plug disconnected. Therefore on completion the fault memories of all control units must be interrogated and erased. To do this:
-
‒ Press key 0 twice for address word "Automatic test sequence" and confirm entry with Q key. The V.A.G 1551 transmits all known address words one after the other.
When a control unit answers with its identification the number of stored faults appears on the display or "No fault recognised".
Any system faults that are stored will be displayed one after the other and printed out. The V.A.G 1551 will then transmit the next address word.
|