Lower the door window until the door window fastening screws -2-are accessible.
Note
If it is not possible to execute this work step due to a damage in the power window drive mechanism, it is possible to remove the motor fastening screws to move the window downwards.
–
Untighten the screws -2- and separate the jaws.
–
Move the door window upwards and fasten (for example, with adhesive tape).
–
Disconnect the connectors -arrows-.
–
Remove the screws -2-.
Tightening torque: 20 Nm
–
Remove the screws -arrows-. Pull the door subframe upwards, raise it and remove it from the door hinge side.
–
Move the subframe and disconnect the connectors from the door locking motor.
–
Remove the clips from the electric harnesses on the back side of the subframe.
–
Remove the clips -1- with a punch.
–
Remove the bellows -1- from the cable -2- and the bellows -6- from the locking rod-5- with the help of a screwdriver.
–
With the help of a screwdriver -3-, raise the door lock -4- with the support -7- from the subframe.
Note
The support does not belong to the door lock set -4-. The door lock is fitted to the support -7- and fastened with a rivet.