Polo Mk4
Rear door window - assembly overview |
1 - | Door |
q | remove and install → Chapter |
2 - | Rear door window |
q | remove → Chapter |
q | install the door window to the window drive mechanism |
3 - | Screw |
q | 2 Nm |
q | 2 units |
q | In assembly, first fasten the upper screw and, then, the lower screw. |
4 - | External door lining |
q | In assembly, first tighten the screws on the right door edge, then the screws on the sequence indicated. |
5 - | Screw |
q | 2 Nm |
q | 2 units |
q | In assembly, first fasten the upper screw and, then, the lower screw. |
6 - | Door window groove |
q | Fitted to the flange and inserted in the door. |
q | With Confortline equipment with the upper edge more compressed. |
7 - | Clip |
q | 5 units |
8 - | Screw |
q | 2 Nm |
q | 2 units |
q | in assembly, first tighten the upper screw and, then, the lower screw |
9 - | Rear packing with the window guide rail |
10 - | Elastic nut |
q | 4 units |
11 - | Intermediate support |
q | External part with clearer marking. |
12 - | External door window packing |
q | Fitted to the flange. |
13 - | Screw |
q | 9 units |
q | 6 Nm |
14 - | Cover cap |
15 - | Subframe |
q | remove and install |
q | The glass lift is a component of the subframe. |
16 - | Window drive mechanism |
q | It is assembled on the back part of the subframe. |
q | The window drive mechanism motor is fastened to the subframe. |
q | Remove the window lift motor → Chapter. |
17 - | Internal door window packing |
q | Fitted to the flange. |