volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Glass pane for sliding / tilting sunroof - height adjustment > < Sliding / tilting sunroof glass pane - remove and install|Removal

Polo Mk4

Installation
Installation
  Note
If, after removing the glass pane, works were performed on the assembly unit (disassembly and assembly, replacement of unit parts) or the drive was removed and the slide guides were displaced, check the parallelism → Chapter first, and when required, adjust → Chapter.
The sliding sunroof guides are in the “open” position.
   
–  Introduce the sliding / tilting sunroof cover from upside and tighten the screws (slide/cover).
–  Moderately tighten the fastening screws -1- (T 25).
  Note
Tighten the fastening screws after adjusting the cover height → Chapter (4.5 Nm).
–  Install the bellows after adjusting the cover's height.
  Note
Do not change the bellows positions.
–  Move the glass pane to the “closed” position.
–  Check position “zero”:
Position zero:
  N60-0134
The mark -arrow- on the upper part of the rear guide -1- must be, on both sides, between the markers -Measure a- in the slide guide -2-.
The slide guide -2- must fit into the guide rail (it does not slide manually when the drive is removed).
If this is not the case, adjust the cover parallelism → Chapter.
–  Adjust the glass pane (height adjustment) → Chapter.
  N60-0109

Glass pane for sliding / tilting sunroof - height adjustment > < Sliding / tilting sunroof glass pane - remove and install|Removal