volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
ABS system components on rear axle (vehicles with disc brakes) - remove and install > < Speed sensor on rear axle (drum brake) - remove and install

Polo Mk4

Rear speed sensor cables - remove and install
Rear speed sensor cables - remove and install
Special tools and workshop equipment required
   
t  Wiring harness repair set -VAS 1978 -
Remove
–  Observe coding in vehicles equipped with code radio. If necessary, request coding.
–  Disconnect the battery → Electrical system; Rep. Gr.27.
–  Disconnect the connector from the speed sensor cable and the speed sensor.
–  Remove the back door sill lining.
–  Move the carpet away from the seat area → General body repairs, interior; Rep. Gr.70.
  W00-0447
–  Remove the rubber bellows -1- and pull the speed sensor cable -2- inside the internal compartment.
  S45-0080
–  Cut the speed sensor cable between -arrows--A- and -B-, using the insulating pliers from the Harness repair set -VAS 1978 -, and remove the defective section -2- from the cable.
Install
–  Insert the new speed sensor cable.
  S45-0080
–  Strip 15 mm of the cable tip with the insulating pliers and turn the stripped cable halfway.
–  Connect the speed sensor cable with the help of a cable fastener from the Harness repair set - VAS 1978-.
–  Connect the speed sensor to its corresponding cable connector.
When installing the speed sensor cable, make sure the cable is not twisted in the wheel housing.
  N97-0016
–  Fasten the rubber bellows -1-.
–  Put the carpet in the seat area again.
–  Install the rear door sill lining → General body repairs, interior; Rep. Gr.70.
  S45-0080

ABS system components on rear axle (vehicles with disc brakes) - remove and install > < Speed sensor on rear axle (drum brake) - remove and install