Polo Mk4
|
| 1 - | H.T. cable |
| q | With suppression connector and spark plug connector. |
| 2 - | Ignition transformer -N152- |
| Marking for ignition cables |
| q | A = No. 1 cylinder. |
| q | B = No. 2 cylinder. |
| q | C = No. 3 cylinder. |
| q | D = No. 4 cylinder. |
| 3 - | Connector |
| q | Black, 4-pin. |
| q | For ignition transformer -N152-. |
| 4 - | 10 Nm |
| 5 - | Connector |
| q | Black, 2-pin. |
| q | For knock sensor 1 -G61-. |
| q | Gold-plated connector contacts. |
| 6 - | Knock sensor 1 -G61- |
| q | Gold-plated connector contacts. |
| 7 - | 20 Nm |
| q | The torque setting influences the function of the knock sensor. |
| 8 - | Connector |
| q | Black, 3-pin. |
| q | For Hall sender -G40-. |
| 9 - | Hall sender -G40- |
| 10 - | O-ring |
| q | Renew if damaged. |
| 11 - | Ignition wiring guide |
| 12 - | Spark plug, 30 Nm |
| q | Remove and install with spark plug spanner -3122 B-. |
| q | Type and electrode gap → Chapter. |
|
| 1 - | Connector |
| q | Black, 4-pin. |
| 2 - | Ignition coil 3 with output stage -N291- |
| q | Remove using puller -T10094-. |
| q | Ignition coil 1 with output stage -N70- |
| q | Ignition coil 2 with output stage -N127- |
| q | Ignition coil 4 with output stage -N292- |
| 3 - | Connector |
| q | Black, 2-pin. |
| q | For knock sensor 1 -G61-. |
| q | Gold-plated connector contacts. |
| 4 - | Knock sensor 1 -G61- |
| q | Gold-plated connector contacts. |
| 5 - | 20 Nm |
| q | The torque setting influences the function of the knock sensor. |
| 6 - | Connector |
| q | Black, 3-pin. |
| q | For Hall sender -G40-. |
| 7 - | Hall sender -G40- |
| 8 - | O-ring |
| q | Renew if damaged. |
| 9 - | 10 Nm |
| 10 - | Spark plug, 30 Nm |
| q | Remove and install with spark plug spanner -3122 B-. |
| q | Type and electrode gap → Chapter. |
| 11 - | Cable guide |
| q | Bolt to camshaft housing with 5 Nm torque. |
| 12 - | Earth wire |
| q | Loosen or tighten only with ignition switched off. |
| 13 - | 10 Nm |
| q | Loosen or tighten only with ignition switched off. |
