Polo Mk4
| Exhaust system - remove and install |
| 1 - | Joint |
| q | Replace |
| 2 - | Exhaust collector |
| q | With connection for exhaust gas return |
| 3 - | Washer |
| 4 - | 25 Nm |
| q | Replace |
| q | Lubricate thread with paste- for heated screws |
| 5 - | Front tube with catalyser |
| 6 - | Retaining ring |
| 7 - | Support |
| 8 - | 23 Nm |
| 9 - | Double brace |
| q | Mind installation position → Fig. |
| 10 - | 40 Nm |
| 11 - | Suspension |
| q | Mind installation position → Fig. |
| 12 - | Suspension |
| q | Mind istallation position → Fig. |
| 13 - | Cutting point |
| q | For repairs |
| q | Characterised by three stampings on exhaust tube bore |
| q | In serial asembly, exhaust tube and rear muffler are assembled as one piece. For repairs, exhaust tube and rear muffler are supplied separately with repair double brace. |
| q | Separate exhaust tube on separation location with a body repair saw, like Body saw -V.A.G 1523/A-, in a right angle → Fig. |
| 14 - | To front muffler |
| q | For repairs, replace individually → Fig. |
| q | Mind installatoin position → Fig. |
| 15 - | 40 Nm |
| q | Replace |
| q | Lubricate thread with paste for heated screws |
|
|
