Polo Mk4
| Engine cooling system components |
| 1 - | 15 Nm |
| 2 - | Water pump |
| q | Check mobility |
| q | Mind installation position |
| q | Remove and install → Chapter. |
| 3 - | Sealing ring |
| q | Replace |
| 4 - | On top of cooling fluid container |
| q | Connectors system for cooling fluid hoses → Chapter. |
| 5 - | Cooling fluid upper tube |
| q | Screwed on head cover |
| q | Connectors system for cooling fluid hoses → Chapter. |
| 6 - | Connection tap |
| q | For heat exchanger |
| 7 - | Distribution piece |
| 8 - | Cooling fluid temperature sensor -G62- |
| q | With sensor to indicate cooling fluid temperature -G2- |
| 9 - | Support lock |
| q | Check grip firmness |
| 10 - | Sealing ring |
| q | Replace |
| 11 - | Distribution piece |
| 12 - | Connection tap |
| 13 - | 10 Nm |
| 14 - | Distribution piece |
| 15 - | 40 Nm |
| 16 - | On top of radiator |
| q | Connector system for cooling fluid hoses → Chapter. |
| 17 - | Cooling fluid tube |
| q | Connector system for cooling fluid hoses → Chapter. |
| 18 - | Below cooling fluid container |
| q | Connector system for cooling fluid hoses → Chapter. |
| 19 - | Below radiator |
| q | Connector system for cooling fluid hoses → Chapter. |
| 20 - | Connector tap |
| q | For cooling fluid thermostat |
| 21 - | Cooling fluid thermostat |
| q | Remove and install → Chapter. |
| q | Mind installation position → Chapter Cooling fluid thermostat - remove and install |
| q | Heat thermostat in a double boiler - check |
| q | Opening start at around 85°C |
| q | Approximated final 105°C |
| q | Opening stroke: minimum 7 mm |
| 22 - | Oil radiator |
| q | Remove and install → Item, → Item |
