–
| Screw Adapter -V.A.G 1381/2- in the place of glower plugs. |
–
| Check compression with Compression tester -V.A.G 1763/-. |
Note Checking equipment handling ⇒ Operation instructions. |
–
| Turn on starting engine until checking equipment no longer indicates rising pressure. |
new: 25...31 bar wear limit: 19 bar |
Cylinders permissible difference: 5 bar |
–
| Place glower plugs with articulated wrench 3220 15 Nm torque. |
–
| Perform test drive and check fault memory → Chapter; check and erase engine command unit fault memory. |
Note As a result of disconnection of the injector pump units connector, faults are stored in memory. That is why it is necessary to check and, if necessary, erase the fault memory. |
|
|
|