Polo Mk4
Note
|
| 1 - | Sealing ring |
| q | Do not lubricate sealing |
| q | Before installation, remove oil residues from crankshaft neck with a clean cloth |
| q | Replace crankshaft sealing - pulley side → Chapter and → Chapter. |
| 2 - | Sealing flange |
| q | Must seat on guide pins |
| q | Remove and install → Chapter. |
| q | Assemble with silicone sealing -D 176 404 A2- → Chapter. |
| 3 - | Engine block |
| q | Crankshaft - disassemble and assemble → Chapter. |
| q | Pistons and nuts - disassemble and assemble → Chapter. |
| 4 - | Wheel |
| q | To remove and install engine wheel, it is necessary to immobilize it with counter-support 3067 |
| 5 - | 60 Nm + 90 ° |
| q | Replace |
| 6 - | Intermediate plate |
| q | Must seat on guide pins |
| q | Do not damage or fold during assembly |
| 7 - | 15 Nm |
| 8 - | Sealing flange with sealing ring |
| q | Replace only sets |
| q | Do not lubricate sealing lip from seal |
| q | Before installation, remove oil residues on crankshaft neck with clean cloth |
| q | To install, use support cap supplied by manufacturer |
| q | Support cap can only be removed after sealing flange has been pushed towards the crankshaft neck |
