Polo Mk4
Note
|
1 - | Upper air duct |
q | Installed on the cross support of instrument panel. |
q | Remove and install → Chapter. |
2 - | Air duct for baffles |
q | Installed on the instrument panel. |
3 - | Air conditioning command and indicator unit / Climatronic -E87- with the Climatronic control unit -J255- |
q | The Air conditioning command and indicator unit / Climatronic -E87- with Climatronic control unit -J255- and the Panel temperature sensor -G56- with Fan for temperature sensor -V42- comprise a single component. |
q | Functions → Chapter. |
q | Remove and install → Chapter. |
q | Check → Chapter. |
4 - | Side air baffle |
q | Remove and install → Chapter. |
5 - | Central air baffle |
q | Remove and install → Chapter. |
6 - | Transverse support on instrument panel |
q | Remove and install → Body - Internal assembly works; Rep. gr.70. |
7 - | Fresh air aspiration duct temperature sensor -G89- |
q | Function: to control the temperature command small door and cold air fan in function of the temperature. |
q | In case of failure, its function is assumed by the External temperature sensor -G17-. |
q | Remove and install → Chapter. |
q | Check → Chapter. |
8 - | Plenum chamber (Climatronic heating and air conditioning system) |
q | Remove and install → Chapter. |
9 - | Front right feet air duct |
q | Remove and install → Chapter. |
10 - | Coupling for the rear air duct |
11 - | Rear air duct |
q | Remove and install → Chapter. |
12 - | Rear right feet air duct |
q | Remove and install → Chapter. |
13 - | Rear left feet air duct |
q | Remove and install → Chapter. |
14 - | Air outlet temperature sensor for the feet region -G192- |
q | Function: controls the air distribution in the feet region and the fan power in function of the temperature. |
q | Remove and install → Chapter. |
q | Check → Chapter. |
15 - | Front left feet air duct |
q | Remove and install → Chapter. |
16 - | Air outlet temperature sensor for the central baffle -G191- |
q | Function: controls the air distribution in the centre baffle outlet and the fan power in function of the temperature. |
q | Remove and install → Chapter. |
q | Check → Chapter. |
17 - | Air outlet temperature sensor for the evaporator -G263- |
q | Remove and install → Chapter. |
q | Check → Chapter. |
18 - | Heat exchanger/engine compartment partition panel sealing |
q | Replace if damaged |
q | Observe the installation position → Chapter. |
19 - | Expansion valve / partition panel seal inside the engine compartment |
q | Replace if damaged |
q | Observe the installation position → Chapter. |
20 - | dash panel |
q | Remove and install → Body - Internal assembly works; Rep. gr.70. |
21 - | Sun irradiation photosensor -G107- |
q | Function: controls the temperature small door and cold air fan in function of the sun radiation. |
q | In case of failure, the Climatronic control unt -J255- assumes a fixed value. |
q | Remove and install → Chapter. |
q | Check → Chapter. |