| –
| Mark the lever position -3- with the small
temperature adjustment door at the end positions (flap fully open -2- and flap fully closed -4-) in the plenum
chamber. |
| –
| Place the adjustment mechanism -1- at the
fully closed flap position -4-. |
| –
| Pull the temperature lever -3- down until
the stop. |
| –
| Install adjustment mechanism -1- on supports -6- and fit the pin on the lever rail -3-. |
| –
| Engage lock -5- in the plenum chamber adjustment
mechanism. |
| –
| Place temperature adjustment button in „cold“ position and install command cable in the adjustment mechanism -1- |
| –
| Check adjustment mechanism operation. |
| All the flaps must move freely and with no jerking movements;
otherwise, remove mechanism and repeat installation. |
| The small temperature door must move easily and without jerking
movements to its final positions (Marks -2- and -4-); otherwise, remove mechanism and repeat installation. |
| –
| Install front left feet air duct → Chapter. |
|
|
|
Note
