Polo Mk4
| Differential: disassemble and assemble |
| 1 - | Screw, 30 Nm |
| 2 - | Converter case |
| 3 - | Retainer for flanged axle |
| q | Before the assembly, fill the space between the sealing lips with multipurpose grease |
| q | It can be replaced with the transmission assembled → Chapter |
| q | Disassemble it with the tool VW 681 |
| q | Fit → Fig. |
| 4 - | Screw, 22 Nm |
| – | Before assembling it, apply sealing paste D/176404/A2 to the screw head. |
| 5 - | Right flanged axle |
| q | Do not mix it with the one in the other side, both axles have different width |
| 6 - | Spring for flanged axle |
| 7 - | Driving washer |
| q | Assembly position: Collar to the spring, core to the conical ring |
| 8 - | Conical ring |
| q | With notches to fit the driving washer |
| q | Assembly position: conical side to the differential case |
| 9 - | Sealing ring |
| q | Keeps the conical ring, the driving washer and the pressure spring in their position when the flanged shaft is disassembled |
| 10 - | Left flanged axle |
| q | Do not mix it with the one in the other side, both axles have different width |
| 11 - | Differential |
| q | Disassemble and assemble → Chapter |
| 12 - | Retaining pin |
| q | To centre the transmission and the converter cases |
| 13 - | Transmission case |
| q | Before assembling the transmission and the converter cases, apply paste D/176 404/ A2 to the sealing surfaces |
| 14 - | Jig bushing |
| q | For the speedometer command |
| 15 - | Speedometer command |
