volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
II - Wheel roller bearings - repair > < Sway bar - remove and install|Removal

Polo Mk4

Installation
Installation
Installation is performed in reverse sequence to the removal, considering the following:
  WARNING
Replace self-locking nuts and screws subject to angular torque
   
–  Install the new rubber bearing -1- on the anti-roll bar through the opening -arrow-.
  Note
t  Make sure the other groove of the rubber bearing -1- touches the stop -2-.
t  Depending on the version, the stop -2- may be located on the right or on the left of the rubber bearing.
–  Install the anti-roll bar and secure it to the console with clamps. Tightening torque, see → Anchor.
–  Console of the auxiliary frame (sub-frame) → Chapter.
–  Attach the steering box to the auxiliary frame (sub-frame). Tightening torque, see → Anchor.
–  Install the front wheel and tighten the screws. Tightening torque, see → Chapter.
  Note
After the installation, check with a drive test check whether the car has no directional trend and if the steering wheel is not in the straight position (wheels forward). In case there is any irregularity, the geometry of the vehicle must be checked.
–  Check the alignment → Chapter.
  N40-10305
Tightening torques
ComponentsTightening torques
Console wishbone
t  Use new fastening screws
20 Nm + 90°
Steering box to the auxiliary frame (sub-frame)
t  Use new fastening screws
50 Nm + 90°

   

II - Wheel roller bearings - repair > < Sway bar - remove and install|Removal