volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Swivel guides - installation position > < Swivel guide - remove and install|Removal

Polo Mk4

Installation
Installation
Installation is performed in reverse sequence to the removal, considering the following:
  WARNING
Replace self-locking nuts and screws subject to angular torque
   
–  Install the swivel tip on the wheel roller bearing case.
–  Tighten the self-locking nuts -arrow-, holding the screw with the Torx T40 wrench. Tightening torque, see → Anchor.
–  To install the drive semi-shaft on the wheel roller bearing case, consult:
t  for vehicles (without ABS) → Anchor
t  For vehicles (with ABS) → Anchor
–  Insert the swivel guide in the wishbone.
  R40-10185
–  Install the fastening screws -arrows- (screws on the old markings) for the wishbone swivel guide. Tightening torque, see → Anchor.
  R40-10071
–  Install the link -3- on the anti-roll bar -2- on both sides. Tightening torque, see → Anchor.
–  Install the front wheel and tighten the screws. Tightening torque, see → Chapter.
–  Install and tighten the grooved nut (dodecagonal). Tightening torque, see → Chapter.
  N40-10382
Tightening torques
ComponentsTightening torques
Wishbone swivel guide
t  Use new fastening screws
20 Nm + 90°
Rollover bar coupling rod
t  Use new fastening nuts
40 Nm
Swivel guide to the wheel roller bearing case.
t  Use new fastening nuts
20 Nm + 90°

   

Swivel guides - installation position > < Swivel guide - remove and install|Removal