Polo Mk4
WARNING
| 1 - | Constant velocity drive semi-shaft - repair . |
| q | different versions |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| 2 - | Suspension column |
| q | Remove and install → Chapter |
| 3 - | Internal grooved screw |
| q | A tip on the hex head screw must point in direction of travel |
| 4 - | Internal hex head screw |
| q | 8 Nm |
| 5 - | Speed sensor |
| q | Remove and install → Break system; Rep. gr.45 |
| 6 - | Hexagonal nut |
| q | Self-locking |
| q | 20 Nm + 90° |
| q | Replace after each removal |
| 7 - | Hexagonal nut |
| q | Self-locking |
| q | 60 Nm + 90° |
| q | Replace after each removal |
| 8 - | Wheel roller bearing case |
| q | For „FS II“ and „FS III“brake calipers |
| q | Different versions for 13" and 14" chassis |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| 9 - | Wheel roller bearing case |
| q | Different versions for 15" running gear |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| 10 - | Steering linkage bar terminal |
| 11 - | Disc guard |
| 12 - | Hexagonal head screw |
| q | 10 Nm |
| 13 - | Grooved nut (dodecagonal) |
| To vehicles without ABS |
| q | Replace after each removal |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| q | Pre-tighten to 200 + 50 Nm, then loosen 180°, and retighten to 50 Nm + 50°, consult → Chapter |
| 14 - | Grooved nut (dodecagonal) |
| For vehicles with ABS. |
| q | Replace after each removal |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| q | Tightening torque for 14” and 15” chassis (silver fastening nut) = 50 Nm + 45, consult → Chapter |
| 15 - | Screw |
| q | 4 Nm |
| 16 - | Ventilated brake disc |
| q | Remove and install → Break system; Rep. gr.46 |
| 17 - | Wheel hub with roller bearing |
| For vehicles with ABS. |
| q | The ABS sensor ring is installed in the wheel hub |
| q | Different versions for 13”, 14” and 15” chassis |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| q | Remove (vehicles with 13” → Chapter chassis) |
| q | Remove (vehicles with 14” and 15” → Chapter chassis) |
| q | Replace, because it is destroyed when removed |
| q | Install (vehicles with 13” → Chapter chassis) |
| q | Install (vehicles with 14” and 15” → Chapter chassis) |
| 18 - | Wheel hub without roller bearing |
| To vehicles without ABS |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| q | Remove and install → Chapter |
| 19 - | Safety ring |
| To vehicles without ABS |
| q | 72 x 2.5 |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| q | Remove and install → Chapter |
| 20 - | Double ball bearing |
| To vehicles without ABS |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| q | Remove and install → Chapter |