volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Metal-rubber bearing - remove and install|Installation > < Metal-rubber bearing - remove and install

Polo Mk4

Removal
Removal
–  Measure the distance from the wheel case to the wheel centre → Anchor.
–  Release the handbrake.
–  Install the Brake pedal pressing device -VAG 1869/2-
–  Lift the vehicle up to working height. → Booklet.
–  Remove the wheels.
–  Disconnect the connector from the speed sensor.
   
–  Remove the speed sensor cable -1- from the clips -arrows-.
  R42-10061
–  Remove the screws from the wheel housing protectors -arrows- on both sides
Vehicles without ABS:
  R42-10064
–  Loosen the screw -arrow-.
Continuation for all vehicles.
  R42-10073
–  Disconnect the brake pipes -arrow A- and remove the clip.
–  Remove the brake hose to the left of the support -2-.
–  Remove the right hose from the rear axle body.
–  Remove the handbrake cables from the support -arrow B-.
–  Remove the handbrake cables from the guide tubes.
–  Place Transmission or engine + transmission set jack or EQ 7081 -VAG 1383A- and Tray for EQ 7081 hydraulic jack -VAG 1359/2- in their positions under the rear axle.
–  Remove the fastening screws/nuts from the rear axle body -1-.
–  Lower the auxiliary frame Transmission jack or engine set + transmission or EQ 7081 -VAG 1383A- and Tray for hydraulic jack EQ 7081 -VAG 1359/2-
  R42-10063
–  Remove the metal-rubber bearing.
1 - Hydraulic pump -VAS 6179-
2 - Assembly tool -VAS 6180/1-
3 - Assembly tool -VAS 6180/4-
4 - Assembly tool -VAS 6180/3-
5 - Assembly device -3416/2-
6 - Assembly tool -VAS 6180/2-
  R42-10069

Metal-rubber bearing - remove and install|Installation > < Metal-rubber bearing - remove and install