Polo Mk4
| Electrohydraulic steering box (JTEKT) - disassemble and assemble |
| 1 - | Steering terminal of linkage bar (right side) |
| q | Marked with „C“ |
| q | Check: → Chapter |
| q | Note the assembly position → Anchor |
| 2 - | Hexagonal nut |
| q | 50 ± 5 Nm |
| 3 - | Clamp |
| q | Replace after each removal |
| 4 - | Protective bellows |
| q | Must not be twisted after adjusting the alignment |
| q | Remove the steering box to replace it |
| 5 - | Clamp |
| q | To replace, open with pliers |
| q | Fasten → Chapter |
| 6 - | Gasket |
| 7 - | Screw |
| q | 8 Nm |
| 8 - | Heat shield |
| q | Only for some markets |
| q | See: → Electronic Parts Catalogue„ETKA“ |
| 9 - | Right steering yoke |
| q | 80 ± 8 Nm |
| q | Remove and install → Chapter |
| q | Supplied as a pre-adjusted replacement part |
| q | Align vehicle → Chapter |
| 10 - | Clamp with nuts |
| q | Replace if threads are damaged |
| 11 - | Rubber bearing |
| 12 - | Steering box |
| q | Remove and install → Chapter |
| 13 - | Gasket |
| q | Replace after each removal |
| 14 - | Power steering sensor -G250- |
| q | Remove and install → Chapter |
| q | Check operation with the Diagnosis, Measurement and Information System -VAS 5051- or Diagnosis, Measurement and Information System -VAS 5052- or later equipment → Vehicle diagnostic tester. |
| 15 - | Screw |
| q | 6 Nm |
| 16 - | Steering terminal of linkage bar (left side) |
| q | Marked with „D“ |
| q | Check: → Chapter |
| q | Note the assembly position → Anchor |
| 17 - | Left steering yoke |
| q | 80 ± 8 Nm |
| q | Remove and install → Chapter |
| q | Supplied as a pre-adjusted replacement part |
| q | Check length and adjust → Chapter |