volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Motor/pump set pressure (JTEKT / TRW) - check > < Motor/pump set - remove and install|Removal

Polo Mk4

Installation
Installation
  Note
t  Use new seal for the duct/hose connections
t  Make sure that the sealing surfaces are clean
Install in the reverse sequence of the removal
–  Replenish with new hydraulic oil, using a funnel and a hose of approx. 400 to 500 mm of length.
–  Use Hydraulic oil -G 004 000 M2-. Refer to the → Chemicals Manual
–  Bleed the steering system → Chapter
–  Check the hydraulic oil level → Chapter.
Tightening torques:
Motor/pump set support to body → Item
Pressure hose to motor/pump set → Item
   

Motor/pump set pressure (JTEKT / TRW) - check > < Motor/pump set - remove and install|Removal