volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Camber on rear axle - adjust > < Vehicles in "zero" transverse tilting position

Polo Mk4

Camber on front axle - adjust
Camber on front axle - adjust
Special tools and workshop equipment required
   
t  Adjustment too -T 40022-
  Note
Displace the auxiliary frame (subframe) to the left or to the right, but never forward of backward!
–  Remove the noise insulation → Body - Assembly works, exterior; Rep. gr.50.
  Q00-10082
–  Install the Adjustment tool -T 40022- with the Adapter -T40022/2- on the floor and console and apply a slight pressure.
  R44-10043
–  Loosen the screws -arrows- that fasten the console and the subframe to the body on only one side.
–  Specifications for camber can be adjusted by turning the cable -arrow A- → Chapter.
–  If the value specified cannot be achieved, then loosen the screws that fasten the console and the auxiliary frame (subframe) to the body on the other side and adjust again.
–  When the value specified is achieved, install new screws on the auxiliary frame (subframe) to body and tighten to the specified torque → Item.
  R44-10044
–  Then, release the cable -arrow A-.
–  Press the Adapter -T40022/2- pin in the direction of the arrow, and remove the adjusting tool.
–  Tighten the fastening screws on the auxiliary frame (sub-frame) to the body → Item.
If a value remains out of tolerance, the transverse inclination of the vehicle must be checked and compensated; if necessary, repeat the adjusting procedure → Chapter.
  R44-10043

Camber on rear axle - adjust > < Vehicles in "zero" transverse tilting position