Volkswagen Workshop Service and Repair Manuals

"CD player" -R89-„RCD 200“ - remove and install Special tools and workshop equipment required

t  Key -T 10057- Removal: –  Turn off the ignition, all the electrical devices, and remove the key from ignition. –  Remove the CD, if any, from the device → Radio Instruction Manual.

–  Insert the Key -T 10057- into the lower and upper sides -arrows- until they fit into the equipment, as indicated below: Top L - above and below, left side Top R - above and below, right side

–  Remove the "CD player" -R89-„RCD 200“ from the panel, pulling it out with the Key -T 10057- in the direction of the -arrows-. –  Pull the equipment out of its housing until the you can reach the connectors in the rear part.

–  Push the connector lock in the direction of the -arrows-.

–  Move the fastening bow upwards, in the direction of the - arrow-, and turn off the connector.

–  Unlock and pull the aerial connector in the direction of the -arrow-.

–  After removing the "CD player" -R89-„RCD 200“, remove the Key -T 10057- by pressing the lock -arrow -. Installation: –  Connect the "CD player" -R89-„RCD 200“ connectors and cable for the Antenna -R11-. –  Install the "CD player" -R89-„RCD 200“, by fitting it completely into the housing in the panel.   Note Never press the command keys or the display during installation, otherwise the device may be damaged. –  Activate the electronic anti-theft alarm system, if necessary → Chapter.