volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
RadioR"BETA" - connector pinout > < RadioR"BETA" - Assembly overview

Polo Mk4

RadioR„BETA“ - remove and install
Radio -R-„BETA“ - remove and install
Special tools and workshop equipment required
   
t  Puller -3316-
Removal:
–  Turn off the ignition, all the electrical devices, and remove the key from ignition.
  W00-0315
–  Introduce the Puller -3316- into the housings -arrows- until they fit onto the device.
  N91-0157
–  Remove the radio from the panel, moving it Puller -3316- towards the -arrows - and pulling it.
–  Disconnect the connector from the Radio -R-„BETA“ and remove the antenna cable.
  R91-10059
–  After removing the Radio -R-„BETA “, remove each Puller -3316- by pressing the lock -arrow -.
Installation:
–  Connect the connectors for the Radio -R-„BETA“ and the Antenna -R11-.
–  Install the Radio -R-„BETA“, by pushing it inside the housing in the dash until it fits in completely.
  Note
Never press the command keys or the display during installation, otherwise the device may be damaged.
–  Activate the electronic anti-theft alarm system, if necessary → Chapter.
–  Check coding of the Radio -R-„ BETA“and, if necessary, adapt → Chapter.
  N91-10003

RadioR"BETA" - connector pinout > < RadioR"BETA" - Assembly overview