volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Left headlight beam reach control motor V48 and/or Right headlight beam reach control motorV49 (Manufacturer - Valeo) - remove |Installation > < Left headlight beam reach control motor V48 and/or Right headlight beam reach control motorV49 (Manufacturer - Valeo) - remove

Polo Mk4

Removal
Removal
  Note
t  If the control motors are removed, installed or replace, an adjustment of the headlight base must always be performed with the adjusting device. The tilting dimension is engraved in the headlight housing.
t  Replacement of control motors is identical on both sides; the procedure below refers only to one side.
–  Turn off the ignition and all electrical equipment, and remove the key from ignition.
–  Disconnect the Battery -A- → Chapter.
   
–  Remove the headlight cover lid -arrow- .
  N94-10346
–  Turn the adjustment motor -2- in the direction of movement -seta- to the stop, and slightly remove it from its fit -1-.
  N94-10347
–  Displace the adjustment motor -3- in order to allow removal of the ball head -2- in the direction of the -arrow- from its fit -1-.
–  Pull the adjustment motor out of the headlight body, observing cable clearance.
  N94-10348
–  Disconnect the connector -1- for the adjustment motor -2-.
  N94-10349

Left headlight beam reach control motor V48 and/or Right headlight beam reach control motorV49 (Manufacturer - Valeo) - remove |Installation > < Left headlight beam reach control motor V48 and/or Right headlight beam reach control motorV49 (Manufacturer - Valeo) - remove