–
| Remove the connector -1- from the lamp. |
–
| Release the locking ring -2- by turning
it to the left. |
–
| Remove the lamp from the reflector. |
–
| Place the new lamp so that the fitting projections are on
the blade disc, located in the reflector cut. |
–
| Lock the locking ring -2- by turning it
to the right. |
–
| Install the cover on the rear section of the headlight support. |
–
| After installing a new lamp, check the headlight operation. |
–
| Check and carry out the headlight adjustment → Chapter. |
|
|
|