volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Turn signal repeater lights - remove and install|Installation > < Turn signal repeater lights - remove and install

Polo Mk4

Removal
Removal
  Note
The turn signal repeater light can only be removed to one direction. You must be very careful during the removal, since it is not possible to see in which side of the the turn signal light the support point is placed in and which side the spring clip is. Tying to forcefully lever the indicator on the spring clip side may damage the indicator or the vehicle painting.
–  Turn off the ignition and all electrical equipment, and remove the key from ignition.
–  Disconnect the Battery -A- → Chapter.
   
–  With a proper tool, move the turn light indicator, carefully move in the supporting point -1-, towards -arrow- against the spring clip force direction -2- and remove it (if necessary, place in advance a masking tape on the painting).
–  Remove the rubber support with the lamp from the indicator light case.
  N94-0289
–  Remove the socket -1- with the lamp from the turn signal repeater light housing -2-.
–  Remove the lamp (12 V - 5 W, yellow glass) from its socket.
  N94-10248

Turn signal repeater lights - remove and install|Installation > < Turn signal repeater lights - remove and install