volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Tightening torques - Battery > < BatteryA console (version 1) - remove and install

Polo Mk4

BatteryA console (version 2) - remove and install
Battery -A- console (version 2) - remove and install
Removal:
–  Turn off the ignition and all electrical equipment, and remove the key from ignition.
–  Disconnect and remove Battery -A- → Chapter.
–  Remove air filter → Engine; Rep. gr.24.
   
–  Loosen securing nuts -1- and fastening screw -2- from the Battery -A-console-3-.
–  Remove the flexible rubber draining tube from the lower part of the Battery -A-console.
–  Remove the Battery -A-console-3- from its housing.
Installation:
Installation is performed in reverse sequence to the removal, considering the following:
  R27-10161
–  Tighten the securing nuts -1- and the fastening screw -2- to the specified torque → Chapter.
–  After installing, check correct seating of the Battery -A- on its console.
  R27-10161

Tightening torques - Battery > < BatteryA console (version 1) - remove and install