Volkswagen Workshop Service and Repair Manuals > Polo Mk4 > Vehicle electrics | Electrical system | Starter-current supply-CC | Starter | StarterB - remove and install | StarterB for vehicles with 1.0l, 1.6l and 2.0l engines (ARA, BAH, BPA, CCRA, BBX, CFEA)

StarterB for vehicles with 1.0l, 1.6l and 2.0l engines (ARA, BAH, BPA, CCRA, BBX, CFEA)

Starter -B- for vehicles with 1.0l, 1.6l and 2.0l engines (ARA, BAH, BPA, CCRA, BBX, CFEA)

Removal:

–	Turn off the ignition, all the electrical devices, and remove the key from ignition.

–	Put the vehicle on a lift in order to make the operation easier.

–	Disconnect the Battery -A- → Chapter.

–	Remove the lower engine noise insulation, if necessary → General body repairs, exterior; Rep. gr.50.

–	Remove gearbox selector lever → Clutch and transmission; Rep. gr.34.

–	Remove securing nut-3- (15 Nm) below the Starter -B- and remove cable support -1-.

–	Remove the fastening screw -2- (80 Nm) for the Starter -B-.

–	Disconnect terminal 50 -1- from Starter -B-.

–	Remove the plastic cover -2- and remove the positive wire -3- from the magnetic switch.

–	Remove hexagonal nut -5- (15 Nm).

–	Remove earth wire -4- and loosen the hex head screw (80 Nm).

–	Remove the Starter -B-.

Installation:

Installation is performed in reverse sequence to the removal, observing the following:

–	Tighten the fastening screws and nuts of the Starter -B- with the specified tightening torque → Chapter.

Volkswagen Workshop Service and Repair Manuals