volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
StarterB - (Manufacturer Valeo) - disassemble and assemble > < StarterB for vehicles with 1.4l engine (BAY)

Polo Mk4

StarterB for vehicles with 1.9l engine (ASY)
Starter -B- for vehicles with 1.9l engine (ASY)
Removal:
–  Turn off the ignition, all the electrical devices, and remove the key from ignition.
–  Disconnect the Battery -A- → Chapter.
–  Put the vehicle on a lift in order to make the operation easier.
   
–  Disconnect terminal 50 -1- from Starter -B-.
–  Remove the plastic cover -2- and remove the positive wire -3- from the magnetic switch.
  N27-0193
–  Remove hexagonal nut -5- (15 Nm).
–  Remove earth wire -4- and loosen the hex head screw (80 Nm).
–  Remove the lower engine noise insulation, if necessary → General body repairs, exterior; Rep. gr.50.
  N27-0193
–  Loosen the securing nut -3- (15 Nm) and remove the support -2-.
–  Loosen the lower fastening screw -arrow- for the Starter -B-.
–  Remove the Starter -B-.
Installation:
Installation is performed in reverse sequence to the removal, considering the following:
–  Tighten the fastening screws and nuts of the Starter -B- with the specified tightening torque → Chapter.
  N27-10212

StarterB - (Manufacturer Valeo) - disassemble and assemble > < StarterB for vehicles with 1.4l engine (BAY)