Volkswagen Workshop Service and Repair Manuals > Polo Mk4 > Vehicle electrics | Electrical system | Wiring | Coupling stations and multi-pin connector | Multi-pin connector in the fire wall | Removing and installing the multi-pin connector on the engine side (version 1)

Removing and installing the multi-pin connector on the engine side (version 1)

Removal:

–	Turn off the ignition and all electrical equipment, and remove the key from ignition.

–	Disconnect the Battery -A- → Chapter.

–	Remove the windscreen wiper mechanism → Chapter.

–	Release the fastening screw -arrow- (7 Nm).

–	Disconnect connectors.

–	Loosen the fastening screw -1- (7 Nm).

–	Unlock the lock -1- by turning it towards the -arrow-.

Note

When removing the multi-pin connector -1- completely, the lock -2- must be positioned as shown in the illustration.

–	Remove the multi-pin connector by the cabin side → Chapter.

Installation:

Installation is performed in reverse sequence to the removal, considering the following:

–	Tighten the securing nuts to (7 Nm).

Volkswagen Workshop Service and Repair Manuals