Volkswagen Workshop Service and Repair Manuals

Main fuse holder (Version 1) - remove and install Removal: –  Disconnect the ground strap and the positive wire from the Battery -A- → Chapter.

–  Release the securing nut -1- (6 Nm) from the B+ cable -2- and remove it.

–  Release the fastening tabs -arrows A- and move away the main fuse holder -2- in the direction - arrow B- of the cover -1-.

–  Move the cover -1- in the direction of -arrow A-. –  Remove the cover -2- in direction of the -arrow- from the supports -1-.

–  Unlock the fastening tabs -arrows- and remove the cover cap -1- from the main fuse holder -2-.

–  Release the securing nuts -1- (6 Nm) and remove the terminals-2-.

–  Unlock the lock -arrow- and remove the fitting fuse holder -1- from the main fuse holder -2-.

–  Move the cable guide -2- in direction of the -arrow- to outside the main fuse holder -1- and position it until permitted by the cable length.

–  Close the main fuse holder -1- in the direction of - arrow A-. –  Remove the main fuse holder -2- in the direction of - arrow B- from the supports -1-. Installation: Installation is performed in reverse sequence to the removal, considering the following: –  Tighten the securing nuts to (6 Nm).