| t
| Battery charger -VAS 5095A- |
Caution | When charging, always set the Battery -A- type at 2.4 V/C (Volt/Cell). This indication is applicable to
all batteries. |
|
Note | t
| The Battery -A- should always be
at a minimum temperature of 10 °C. |
| t
| Do not open the caps of batteries with removable caps during
charging. |
| Carry out the following tasks: |
| –
| Turn off the ignition and all electrical components. |
| –
| Check the Battery -A- type setting
on the selection switch for the type of Battery -A- → Fig.-9-. This should be set to 2.4 V/C (Volt/cell). |
| –
| Connect the red charging terminal „+“ of the
charger to the positive pole of the Battery -A-. |
| –
| Connect the black charging terminal „-“ of
the charger to the negative pole of the Battery -A-. |
| –
| Turn on the charger → Fig.-1-. |
| The indications of the charge current → Fig.-2- and -3- are indicated by a LED (yellow). The Battery -A- will be partially charged (approx. 90 %) when the LED
(yellow) -3- lights up. |
| If the LED (green) → Fig.-4- also lights up, the charger has commuted to a trickle
charge. The Battery -A- is charged. |
| –
| Turn off the charger → Fig.-1-. |
| –
| Remove the charging terminals from the poles of the Battery -A-. |
|
|
|
WARNING
