| Auxiliary operations with the Battery charger -VAS 5903- |
WARNING | Risk of injuries! Pay attention to the warning notes and security
norms → Chapter. |
|
| Supporting operations supplies power to on-board systems when
the Battery -A- is disconnected or out
of the vehicle. |
| Support operations are suitable for the following situations: |
| t
| Supporting operations of on board systems without an installed Battery -A- |
| t
| Maintenance of voltage in the event a Battery -A-is replaced |
| t
| Aggregated testing without a Battery -A- |
| –
| Turn off the ignition and all electrical components. |
Caution | t
| The protective device for the proper connect of the charge
terminals is not activated in the „charging of completely drained
batteries/auxiliary operation“ mode. Connect the poles of the
charging terminals to the terminals of the poles of the Battery -A-correctly. |
| t
| Do not press the START/STOP button if the connection
of the charge terminals is incorrect! It could damage the charger. |
|
| –
| Remove the Battery -A-. |
| –
| Connect the charger to a power source. The last mode of
operation selected will appear on the display → Fig.-1-. |
| –
| Connect the red charging terminal „+“ of the
charger to the positive pole of the Battery -A-. |
| –
| Connect the black charging terminal „-“ of
the charger to the negative pole of the Battery -A-. |
| –
| Press the START/STOP button. 5 seconds. The
menu „charging of completely drained batteries/auxiliary operation“ will be activated. |
| –
| Press the „Up“↑ or „Down“↓bottom, in order to set the voltage corresponding
to the Battery -A- (6V, 12V or 24V). |
Note | If no button is pressed for 5 seconds, the charger will return
to the main menu (select type of operation). |
| –
| Confirm the Battery -A- voltage
selected with the START/STOP button. |
| Next the correct connection of the charging terminal poles
is requested. |
| –
| Check that the poles of the charging terminals are correctly
connected. |
| –
| Confirm the correct connection of the charging terminal
poles with the START/STOP.button. |
| The charger initiates auxiliary operation. |
| –
| Replace the Battery -A-. |
| –
| Press START/STOP to conclude auxiliary operation. |
| –
| Connect the black charging terminal „-“ of
the charger to the negative pole of the vehicle. |
| –
| Connect the red charging terminal „+“ of the
charger to the positive pole of the vehicle. |
| –
| Disconnect the charger from its power source. |
|
|
|
