volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing front seat backrest cover and padding > < Front seat covers and padding|Tools

Polo Mk5

Removing and installing front seat cushion cover and padding
Removing and installing front seat cushion cover and padding
  Note
t  Removal and installation is described for the left seat. Apply the same instructions for removal and installation of right seat components as appropriate.
t  Removal and installation are examples and apply to all equipment lines.
  WARNING
If the front passenger seat cushion padding is renewed, the seat occupied sensor, front passenger side -G128- must also always be renewed → Chapter.
Removing
–  Remove front seat → Chapter.
–  Removing front belt buckle → Chapter.
–  Removing seat trim on tunnel side → Chapter.
–  Removing seat trim on sill side:
t  Seat without height adjustment → Chapter.
t  Seat with height adjustment → Chapter.
–  Removing mounting for drawer, if fitted → Chapter.
   
–  Unscrew bolt -1- (3 Nm) and remove bracket -2-.
  N74-10228
–  Unclip clamped section -3- from seat frame -4-.
–  Unclip seat heater connector, if installed, from retainer und seat.
–  Unhook padding wire -1- from padding using awl -V.A.G 1636-.
–  Take cover -2- and padding -5- ff seat frame.
–  Remove cover.

Installing
  Note
t  In the seat padding in vehicles with a seat heater is renewed, the heating element is also to be renewed.
t  Assure a dust free adhesive area on the padding.
t  Bond heater element fold-free to padding.
Installation is carried out in reverse order.
   

Removing and installing front seat backrest cover and padding > < Front seat covers and padding|Tools