volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Engine cylinder head, valve gear > < Renewing crankshaft oil seal - belt pulley end

Polo Mk5

Renewing crankshaft oil seal - flywheel end
   
Renewing crankshaft oil seal - flywheel end
Special tools and workshop equipment required
t  Puller hooks -2086-
t  Torque wrench -V.A.G 1331-
t  Torque wrench -V.A.G 1332-
t  Fitting tool -T10122-

  Note
t  For the sake of clarity, the work is performed with the engine removed.
t  The procedure is identical whether the engine is installed or removed.
Removing
–  Remove flywheel or drive plate as applicable.
   
–  Remove seal using extractor hook -2086-.
Installing
  Note
Do not remove support ring from seal until immediately before installation.
–  Assemble fitting tool sleeves-T10122/1- and -T10122/2-.
  N15-0514
–  Push seal -A- onto fitting tool sleeve-T10122/2- to stop.
–  Separate the two fitting sleeves.
  N13-0782
–  Fit assembly sleeve -T10122/2- together with oil seal on crankshaft flange.
–  Press oil seal in to stop using fitting tool -T10122/3-.
Further assembly is basically the reverse of the dismantling sequence.
  N13-0783

Engine cylinder head, valve gear > < Renewing crankshaft oil seal - belt pulley end