volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing headlight range control motor > < Renewing side light bulb

Polo Mk5

Renewing front turn signal bulb
Renewing front turn signal bulb
  Note
t  The illustrations show how to change the bulb of the left headlight.
t  The bulb of the right headlight is replaced in the same way.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
–  Remove headlight → Chapter.
   
–  Remove cover cap -1-.
  N94-11709
–  Turn bulb holder -1- in direction of -arrow- and pull front turn signal bulb backwards out of headlight.
  N94-11712
–  Push front turn signal bulb -2- into bulb holder -1- and turn bulb in direction of -arrow-.
–  Push bulb into bulb holder in direction of -arrow- and pull out front turn signal bulb -2- out of bulb holder -1-.
Installing:
  Caution
When installing cover cap, ensure cap is seated correctly. The ingress of water will lead to permanent damage to the headlight.
  Note
Do not touch bulb glass when fitting bulbs. Fingers leave traces of grease on the glass, which evaporate when the bulb is switched on and cause the glass to cloud over.
Installation is carried out in the reverse order. When installing observe the following:
–  Check headlight functions.
  N94-10237

Removing and installing headlight range control motor > < Renewing side light bulb