Quantum L4-1588cc 1.6L DSL SOHC Turbo (1982)
Install and connect indicator light as follows:
-
remove trim plate for rocker switches
-
remove blank from left side switch opening
-
mark and drill a 9 mm hole in center and mount indicator light in blank
-
connect both yellow and white wires (included in Kit) to indicator light
-
reinstall switch blank, routing wires through dash to control unit
-
connect white wire to one male terminal of double connector on terminal 15 of control unit
-
connect yellow wire to terminal 31b of control unit
-
reinstall trim plate for rocker switches
-
connect black wire (included in Kit) to remaining male terminal of double connector on terminal 15 of control unit
-
route wire to rear of Fuse/Relay Panel and connect to terminal G1, using additional double connector if necessary
-
connect brown wire to terminal 31 of control unit, and to ground cluster under dash
Note - Turbo only
Fuel filter has rubber mounts. To insure adequate grounding of filter on these models, a ground wire should be made and installed to bridge rubber
mounts on filter
-
reinstall Fuse/Relay Panel
-
reinstall fresh air duct
-
reinstall left side underdash trim and closeout panels
-
reconnect battery
-
test system by switching ignition on and grounding blue wire from sensor on fuel filter casing. Light should come on and remain on until ignition is
switched off
Suggested Installation:
75 T.U.
Labor Operation:
20 34 31 0