R32 4Motion V6-3.2L (CBRA) (2008)
/Page-1380002.png)
^
This torque specification applies only in conjunction with insert Tool 18 mm T10179.
7 - Subframe
8 - Bolt
^
M12 x 1.5 x 125
^
90 Nm plus an additional 90° turn
^
Always replace after removal
9 - Lower transverse link
10 - Nut
^
M12 x 1.5
^
90 Nm plus an additional 90° additional turn
^
Self-locking
^
Always replace after removal
^
Always tighten bolts in curb weight position
11 - Bolt
^
Always replace after removal
12 - Threaded rivet
^
M6
13 - Expanding rivet
14 - Stone protection plate
15 - Bolt
^
8 Nm
16 - Nut
^
M14 x 1.5
^
130 Nm plus an additional 90° turn
^
Self-locking
^
Always replace after removal
^
Always tighten bolts in curb weight position
17 - Bolt
^
Always replace after removal
^
Always tighten bolts in curb weight position
18 - Upper control arm
19 - Washer
20 - Nut
^
M14 x 1.5
^
130 Nm plus an additional 90° turn
^
Self-locking
^
Always replace after removal
21 - Wheel Bearing Housing
^
A mixed installation of aluminum wheel bearing housings is permissible
^
Only aluminum wheel bearing housing are available as a replacement part; therefore when exchanging, there are certain parts which must be
exchanged and/or additionally installed.
22 - Washer
23 - Bolt
^
Always replace after removal
^
Always tighten bolts in curb weight position.
24 - Tie Rod
^
Closed in direction of travel
25 - Bolt
^
Always replace after removal
^
Always tighten bolts in curb weight position.
26 - Nut
^
M12 x 1.5
^
90 Nm plus an additional 90° turn
^
Self-locking
^
Always replace after removal
