Rabbit L5-2.5L (BGP) (2006)
4-door vehicles
-
Open flap - 1 - in lower area of B-pillar.
-
Press floor covering slightly to side and remove screw - 2 - (40 Nm).
-
Remove belt anchor - 3 - from body.
2-door vehicles
-
Remove seat bench.
-
Remove 2-door sill panel trim.
-
Remove anchor rail from seat belt.
All vehicles
-
Pull seat belt through trim opening.
Installing
NOTE:
-
When installing, driver for belt height adjuster - 4 - and button in trim - 3 - must be located in the same position.
-
Before installation, clip must be checked for damage and replaced if necessary.