Rabbit L5-2.5L (BGP) (2006)
Make sure that brake fluid does not come in contact with the terminals.
-
First, mark both brake lines from master cylinder - A and B - and remove from hydraulic unit.
-
Plug brake lines and threaded holes immediately with sealing plugs from repair kit Part No. 1H0 698 311 A.
-
Mark brake lines (brake caliper) - 1 to 4 -, remove and seal.
-
Pull hydraulic unit with control module upward out of shock absorbers.
Control module, removing from hydraulic unit
-
Set hydraulic unit with control module upward on to a clean, level surface.
-
Remove inner Torx bolts - arrows -.